There is 1 critical problem I?m facing. 1 Cisco 1751 Router is configured for Dial-in. Async interface 1 is connected to Telephone line. Now I connected another local telephone line to Laptop & configure the modem setting same as Router. Now I create the dial-up connection on Laptop & dial the Router phone no. Call is established & It?s asked for Username & Password & verifying it. After some seconds the following error appeared.
?Error 791 Remote computer not responding? & Call is being disconnected.
Pls see the router configuration below. I have done same configuration on 2500 router. It?s working fine. Hope You will be reply soon.
Current configuration : 2015 bytes
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
enable secret 5 $1$m6Xc$swVAV8EpmJbR6tnVRf2Xm1
memory-size iomem 20
clock timezone IST 0
mmi polling-interval 60
no mmi auto-configure
no mmi pvc
mmi snmp-timeout 180
no aaa new-model
ip audit po max-events 100
isdn switch-type basic-net3
chat-script offhook " " "ATH1" ok
username cisco password 0 cisco
ip address 172.17.64.1 255.255.255.224
description ***** Connected to Norther Regional Head Quarter *****
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...