Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 2811 not going ahead from Switch:

Router Details :

model number Cisco 2811

With switch model detail- NME-16ES-1G-P

PROBLEM FACING:

once if you switch from router to switch its showing as

Switch :

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Cisco 2811 not going ahead from Switch:

To download an image you need a valid Cisco contract which i think you have.

The EtherSwitch service modules support the same Cisco IOS Software images as the Catalyst 3750 and Catalyst 3750-E Series Switches

YOu can download the image to the router flash and then do an xmodem to transfer it to the ether switch module.

Have a look at the software section in the below link

http://www.cisco.com/en/US/prod/collateral/routers/ps5854/prod_qas0900aecd8028d16a_ps5855_Products_Q_and_A_Item.html

HTH

Narayan

8 REPLIES

Re: Cisco 2811 not going ahead from Switch:

It seems that the etherswitch module image is corrupted.

Have a look at this link to recover a corruspted image

http://www.cisco.com/en/US/docs/ios/12_3t/12_3t14/feature/guide/miragenm.html#wp1768057

HTH

Narayan

New Member

Re: Cisco 2811 not going ahead from Switch:

Want to ask you following question:

Is the ether switch module image/IOS loaded in the same flash where router image/IOS is loaded.

How can I download the image from the cisco link?

Could you provide me the ether switch image name specific to 2811 router.

I have already tried downloading the correct image from the Cisco site using software advisor, but couldn't find the correct image.

Pls Help

Rgds,

Ashish

Re: Cisco 2811 not going ahead from Switch:

To download an image you need a valid Cisco contract which i think you have.

The EtherSwitch service modules support the same Cisco IOS Software images as the Catalyst 3750 and Catalyst 3750-E Series Switches

YOu can download the image to the router flash and then do an xmodem to transfer it to the ether switch module.

Have a look at the software section in the below link

http://www.cisco.com/en/US/prod/collateral/routers/ps5854/prod_qas0900aecd8028d16a_ps5855_Products_Q_and_A_Item.html

HTH

Narayan

New Member

Re: Cisco 2811 not going ahead from Switch:

Can I download any of Cat3750 or Cat3750-E series IOS and upload the same in the router flash ?

Rgds,

Ashish

Re: Cisco 2811 not going ahead from Switch:

yes (above 12.2(25)EZ) as long as you have a valid Cisco contract..

Narayan

New Member

Re: Cisco 2811 not going ahead from Switch:

I ve downloaded c3750-ipservicesk9-mz.122-46.SE

do you think it will work.

Rgds,

Ashish

Re: Cisco 2811 not going ahead from Switch:

yes.

follow the recovery procedure link posted earlier

Narayan

New Member

Re: Cisco 2811 not going ahead from Switch:

Thanks Narayan,

The issue got resolved.Thanks a tonne once again for all your support and valuable help.

Regards,

Ashish

319
Views
0
Helpful
8
Replies