I recently took over the network manager possition. The win2003 server that was set up to handle dialin authentication from our cisco 3600 crashed and had to be replaced. restoring from backup was not a good option , so I started completely over.
The cisco 3600 was set to authenticate to the windows server but I can not seem to get IAS to accept anyones login. can anyone point me to a setup guide that covers setting up a cisco 3600 to authinticate to a windows2003 server?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...