Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 3750G Express Setup

I am unable to login to my express setup on my 3750G

I have done everything?

I have also factory rebooted my switch

It has IOS 12.2


Re: Cisco 3750G Express Setup

New Member

Re: Cisco 3750G Express Setup

check out the express setup is enabled on your switch. by default it is enabled.

Check out if this link can help you out.

New Member

Re: Cisco 3750G Express Setup

In a recent project that I am doing I have 2 cisco 3750G switches straight out of the box, two TFOCA boxes, two SX-MM, two Orange fiber patch cables and two yellow fiber patch cables.

Now the setup that i have looks kinda like this:

Switch1 --- Gbic --- Orange fiber -- TFOCA --Tactical Fiber -- TFOCA --- Orange fiber --- Gbic --- Switch2 /24 /24

Each GBIC is plugged into G1/0 which is the GBIC slot on both switches. I have each port set to Trunking:

sw trunk encap dot1q

sw mode trunk

no shut

When I go to each switch and type show cdp neigh I see the other switch on both switches. But when I go into Switch 1 and try to ping the other switch it goes through, but when I go into switch 2 I cannot ping the other. I know its a simple problem, but for some reason I cannot get it to work. here is the trouble shooting that I have done below:

Traded out the orange fiber patch cable with the yellow.

Light test on all Fiber which went though.

Traded out GBICS

Traded out multiple Orange/yellow fiber patch cables.

swapped TX to RX on one switch at a time.

Swapped GBIC slots on both Switches

With my knowledge I have troubleshooted as much as I know, but still cannot get Switch 2 to talk to Switch1. its something simple that I'm overlooking, but I have no idea what it is.

More info in spanish go to my articles site on and