10-09-2008 03:10 AM
I have a Cisco 851 and try to configure PPPoE to my provider. IOS 12.4(15)T7. And there are no interface command 'pppoe enable' in this IOS. What can I do? Without this command nothing is working (see the attachement).
10-09-2008 06:31 AM
Here's is a working config for PPPoE.
interface FastEthernet4
description Physical Connection to Internet
no ip address
no ip redirects
no ip unreachables
no ip proxy-arp
ip route-cache flow
duplex auto
speed auto
pppoe enable group global
pppoe-client dial-pool-number 1
no cdp enable
interface Dialer0
description OUTSIDE
ip address 75.x.x.x 255.255.255.248
ip mtu 1452
ip nat outside
ip virtual-reassembly
encapsulation ppp
ip route-cache flow
dialer pool 1
dialer-group 1
ntp disable
no cdp enable
ppp authentication pap callin
ppp pap sent-username joe.snuffy@static.sbcglobal.net password 0 MySeCrEt
Hope that helps.
10-09-2008 06:05 PM
I can't enter the command 'pppoe enable group global'. There are no this command in my IOS!
10-13-2008 08:18 PM
remove the group global part of the command and just use pppoe enable.
eg:
int fa0/0
pppoe enable
pppoe-client dial-pool-number 1
int dail0
ip address negotiated
ip mtu 1492
dial pool 1
10-13-2008 09:01 PM
There are no comand 'pppoe enable'.
10-15-2008 02:20 AM
I am having the same problem with the version Cisco IOS Software, C850 Software (C850-ADVSECURITYK9-M), Version 12.4(15)T7, RELEASE SOFTWARE (fc3) on the other hand this command is showing up fine in the version Cisco IOS Software, C850 Software (C850-ADVSECURITYK9-M), Version 12.4(11)T2, RELEASE SOFTWARE (fc4).
Is that relate to the problem with the version of IOS?
Thank you
Yamin
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide