_ configure WAN port (Dialer0 on FE4) of Cisco 871 for the PPPOE negotiation and configure IP UNNUMBERED with the VLAN of DMZ port (VLAN10, see following config)
_ configure DMZ (FE3) with first public ip (xxx.yyy.zzz.249) assigned to VLAN10, that permit to connect directly some server using the other public IP assigned from the provider (xxx.yyy.zzz.250 .. xxx.yyy.zzz.254)
_ configure FE0/FE1/FE2 for the internal LAN (10.10.1.0/24), natted with the Dialer port.
_ configure DHCP server for the LAN port (FE0/FE1/FE2) for the range 10.10.1.60-10.10.1.99
_ configure an ACL to enable full access from LAN to DMZ
_ configure an ACL to enable full access from LAN to WAN
This is my configuration, but I don't find why doesn't work. Anyone can help me ?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...