At the risk of looking like a fool, I need a small bit of help.
I have a 1841 with a public IP connected to a small /27 vlan which routes to a /18 vlan. However it does not want to work. I'm begining to suspect NAT as the problem, funny thing is I've done a few IOS vpn setups and have yet to have a problem, the only difference is this case has 2 vlans whereas normally the it is one vlan only. Can anyone spot any mistakes below?
FTR I've been tinkering with ACL 101,105 and 106
I've attched the config, the clients route table, ipconfig and a debug on the router.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.