Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco VPN 4.8.01 client to Netgear DG834G

Can anyone explain to me or point me in the direction where I can find info on how to connect a VPN from a Netgear DG834G to a windows Cisco 4.8.01 client.

I used the VPN wizard on the Netgear and created a connection with the following config:

Secure Association Main Mode

Authentication Method: Pre-shared Key

Encryption Protocol: 3DES

Authentication Protocol: SHA-1

Diffie-Hellman (DH) Group: Group 2 (1024 bit)

Local Identity Type: WAN IP address

Remote Identity Type: IP address

There aren?t many options on the Cisco VPN client. I tried using Group Authentication but what do I use for a name, I presumed the password would be pre-shared key?

I also tried editing the Netgear config and using a Local and Remote identity and putting that in the name but I?m not having much luck.

Any advice would be much appreciated ? can it be done ?

Thanks

Steve

2 REPLIES
Cisco Employee

Re: Cisco VPN 4.8.01 client to Netgear DG834G

Steve,

The Cisco VPN Client supports the following Cisco VPN devices only.

?Cisco VPN 3000 Concentrator Series, Version 3.0 and later.

?Cisco PIX Firewall, Version 6.2.2(122) or Version 6.3(1).

?Cisco IOS Routers, Version 12.2(8)T and later

So, it is not possible to cofigure the Cisco VPN Client to work with Netgear VPN Servers.

Please refer the release notes for details:

http://www.cisco.com/univercd/cc/td/doc/product/vpn/client/rel_4_8/48client.htm#wp1024664

I hope it helps.

Regards,

Arul

** Please rate all helpful posts **

New Member

Re: Cisco VPN 4.8.01 client to Netgear DG834G

Thanks very much for the advice, won't pursue any further.

1177
Views
5
Helpful
2
Replies
CreatePlease login to create content