Cisco VPN Concentrator 3005 Site-to-Site...multiple Static NAT rules

[twebb]

We have a 3rd party that we have established a site-to-site tunnel with on a 3005 Cisco...that was easy enough.

The problem is they are monitoring 13 servers of ours which have private ip addresses and they need to have these servers NAT'd to 13 of our public addresses. I can't seem to get this to work in the concentrator configuration page. Is this possible to do with the 3005? I can give more information if needed--didn't know if anyone had experienced this before.

Thanks,

Tyler Webb

[carenas123]

NAT cant be configured on a VPN 3005.We need to have an external device in order to configure NAT.Refer the following URL

http://www.cisco.com/en/US/products/hw/vpndevc/ps2284/products_configuration_example09186a00801ae24c.shtml