I am having real trouble setting up a Cisco 2811. I am connecting it to an E1 ISDN30 line and using it for remote user pstn dial up.
The users can dial in, be authenticated via EAP and given an IP address no problem. They can work happily on the network for approx 139 seconds before they are booted off. By this I mean the connection simply drops out. The debugs (attached) seem to indicate a fairly normal hang up but I cant figure out why they are doing it.
As I said the router is a Cisco 2811 with 2 * E1 Wics installed and a PVDM2 modem bank.
The IOS is 12.4(13)R.
The E1 line is good, I have checked it out with a spare 3640 I have and it keeps the line up.
I have attached the config also, any advice greatly appreciated,
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...