Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

configure out of band access on 1600 series routers

Hi,

I am running into a issue with configuring 1600 series routers console port for dial in purposes. I get a error " Line does not support modem control." How can I configure dial in access as reverse telnet does not work with console port.

1 REPLY
Bronze

Re: configure out of band access on 1600 series routers

Hi,

the console port indeed does not support RS232 modem control (data set ready/Data Carrier Detect (DSR/DCD), data terminal ready (DTR)). However, you cannot change the settings on the console port. You need to configure your modem to to ignore DTR and assert autoanswer. The associated Hayes-compatible commands are AT&D0 and ATS0=1, respectively.

Regards,

Nethelper

123
Views
0
Helpful
1
Replies
CreatePlease to create content