Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Configuring DDR with Object Tracking

Greetings,

I'm having a problem setting up a DB solution using object tracking. First, the article states DDR must be configured first, which confuses me.

Internet Access, either T1 or otherwise, where all traffic is routed thru the VPN tunnel. I'm hitting a server on the other side of the tunnel with this:

ip sla monitor 1

type echo protocol ipIcmpEcho 10.16.5.130 source-interface FastEthernet0/0

threshold 5

frequency 5

ip sla monitor schedule 1 life forever start-time now

track 123 rtr 1 reachability

this works, UNTIL, I do this:

ip route 0.0.0.0 0.0.0.0 68.165.x.x track 123

The traffic drops. I must include another duplicate entry withouth the track 123 statement and the tracking works.

Using the Route-map also breaks the sla monitor:

access-list 105 permit icmp any host 10.16.5.130 echo

route-map TEST permit 10

match interface 105

set interface BRI0/1/0 Null0

I've added my secondary route as well. how is the dialer or bri interface triggered? Should I use a profile? Do you still have to use a backup command?

I just don't get this.

2 REPLIES
Silver

Re: Configuring DDR with Object Tracking

Run the command `show track'

is your object 123 up?

If not can you ping 10.16.5.130 across the tunnel using F0/0 as the source?

Andy

New Member

Re: Configuring DDR with Object Tracking

I'm having this same issue. Can I ask what you had to do to get around this, an example config would be great!

Thanks!

121
Views
0
Helpful
2
Replies