Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Configuring lines 1 60 on Cisco 2821

Hi all,

I'd like to know what is necessary to configure the parameter line 1 60 in a Cisco 2821 router with a two E1's direct connected in a interfaca VWIC2-MFT-E1 and two PVDM's modules installed.

When I try to enter the line "router(config)#line 1 60" the ios returns an error message that there are no physical hardware to support "line 2". I just can enter line 1.

Which is necessary to do this?

My best Regards,

Adriano

1 REPLY
Silver

Re: Configuring lines 1 60 on Cisco 2821

try to do a show of the interface using the following example and see the output.

#sh voice po 1/1

215
Views
0
Helpful
1
Replies