Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

configuring VPN router

Good Day to all,

i have a public ip, can anyone assist me on how to configure my 2821 router as a VPN server?

thank you,

lester

3 REPLIES
Silver

Re: configuring VPN router

The AutoInstall process configures the router automatically after connection to the WAN. A Transmission Control Protocol/Internet Protocol (TCP/IP) host on your network must be preconfigured to provide the required configuration files. The TCP/IP host may exist anywhere on the network provided the following two conditions are met:

1. The host must be on the remote side of the router's synchronous serial connection to the WAN.

2. User Datagram Protocol (UDP) broadcasts to and from the router and the TCP/IP host are enabled.

Do not use AutoInstall unless the required files are available on the TCP/IP host. Refer to the publications Configuration Fundamentals Configuration Guide and Configuration Fundamentals Command Reference for information about how AutoInstall works

New Member

Re: configuring VPN router

Hi Aghaz,

I am also having doubt about configure vpn router as like lester so can u give what are the step by step we need to configure in router & what are the commands we need to enable after connect wan link in router serial int.

Any body can explain it would be appreciated.

Thanks in advance.

naidu.

Cisco Employee

Re: configuring VPN router

Hi,

Please refer the below URL for configuration details.

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_tech_note09186a0080094203.shtml#ipsec

I hope it helps.

Regards

Arul

298
Views
0
Helpful
3
Replies
CreatePlease to create content