Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

copying config into routers via putty

When logging in remotely using putty, port 22, everything is fine until I need to paste a configuration into the config. Basically the first character getrs cut off and the only way I have figured out to get around this is to put a space before everyline prior to copying.

Has anyone had this issue before, i know its not a major thing, but when it comes to large configs and adding a space to every line it gets tiresome...

thanks a lot

2 REPLIES
VIP Purple

Re: copying config into routers via putty

Hello,

which OS are you running putty on ? Doing the same thing as you described on my XP workstation, I cannot replicate that problem...can you post the output of 'show terminal' from the router where you are trying to paste to ? I can compare that to the terminal settings of my router, maybe there is something different...

Regards,

GP

New Member

Re: copying config into routers via putty

Router#sh terminal

Line 0, Location: "", Type: ""

Length: 24 lines, Width: 80 columns

Baud rate (TX/RX) is 9600/9600, no parity, 2 stopbits, 8 databits

Status: PSI Enabled, Ready, Active, Automore On

Capabilities: none

Modem state: Ready

Modem hardware state: CTS* noDSR DTR RTS

Special Chars: Escape Hold Stop Start Disconnect Activation

^^x none - - none

Timeouts: Idle EXEC Idle Session Modem Answer Session Dispatch

00:10:00 never none not set

Idle Session Disconnect Warning

never

Login-sequence User Response

00:00:30

Autoselect Initial Wait

not set

Modem type is unknown.

Session limit is not set.

Time since activation: 00:01:14

Editing is enabled.

History is enabled, history size is 20.

DNS resolution in show commands is enabled

Full user help is disabled

Allowed input transports are none.

Allowed output transports are pad v120 telnet rlogin.

Preferred transport is telnet.

No output characters are padded

No special data dispatching characters

Router#

1315
Views
0
Helpful
2
Replies