When you associate isakmp with the interface, that determines what the PIX will use as a source address. Since the PIX does not operate with the concept of multiple output interfaces that can get to the same destination, as the IOS does, it does not need a command like local-address which changes the default association of outbound interface as the source address for VPN traffic.
I am not clear what you are attempting to accomplish. Perhaps if we understood this we could find an alternative that would help you.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...