09-25-2007 03:34 AM
Hello,
i cannot establisg a call from bri to E1. Iam doubting part of the debug which shows
Transfer Capability = 3.1kHz Audio
will the above message (parameter) allow incoming data calls?
09-25-2007 11:34 AM
The call is coming as either voice or fax/modem. Whic hardware do you have, and what is calling ?
09-25-2007 09:13 PM
calling party is BRI and the called party is E1.
we cannot establish the call. But if we do it the other way around (E1 to BRI) it will work.
we have this conf on E1
controller E1 2/0
framing NO-CRC4
pri-group timeslots 1-10,16
interface Serial2/0:15
no ip address
encapsulation ppp
dialer pool-member 5 max-link 2
isdn switch-type primary-net5
isdn incoming-voice modem
ppp authentication chap
ppp multilink
09-26-2007 01:46 AM
which hardware and IOS are you using ?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide