Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DHCP address relay

Hi all,

As of recent i have put in these cisco 1812's and configuring them so they have remote vpn access enabled. For this i configure a dhcp relay on the internal interface and then use the "crypto isakmp client configuration group [NAME]" command to configure the DHCP settings.

The last cisco i tried was an 1841 and it did not have the DHCP command, so i am unable to set the giaddr or DHCP server. Does anyone have any idea why i cannot use these commands ?

(I have disabled DHCP server as well on the router)

Regards,

Nathan

1 REPLY
Silver

Re: DHCP address relay

Try this DHCP configuration.

router>enable

router#config t

router(config)#service dhcp or router(config)#ip bootp

router(config)# ip dhcp pool TEST

router(dhcp-config)# network X.X.X.X Y.Y.Y.Y ( ip address and subnet

mask that the LAN will use )

router(dhcp-config)# dns-server {ip of dns1} {ip of dns 2}

router(dhcp-config)# default-router Z.Z.Z.Z ( internalip address of the router)

router(dhcp-config)#ctrl-z <----to exit

router(dhcp-config)#ip dhcp excluded-address

To use a remote dhcp server

router>enable

router#config t

router(config)# ip helper-address x.x.x.x <---- ip address of the

remote dhcp server router(config)#exit

254
Views
0
Helpful
1
Replies