Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Dial-in to a 2821 with WIC-2AM-V2

Was hoping to get some help on this.  We have a spare ISR 2821 with 2 WIC-2AM-V2 cards.  We would like to be able to use this router as a backdoor dialup connection incase our VPN/Internet connection goes out.   Is it possible to do this with this router and if so is there a sample config I could look at?

In the end I'd like to have this router be able to accept dial-in connections to allow us access to our network with the proper authentication (TACACS+)

Thanks,

James

1 REPLY
Cisco Employee

Re: Dial-in to a 2821 with WIC-2AM-V2

Hi thete,

Here are some links that has some sample configs and troubleshooting tips. The configs for different modem modules will be same as discussed in those links.

Configuring Dialin with the NM-8AM or NM-16AM Analog Modem Module

http://www.cisco.com/en/US/partner/products/hw/modules/ps2740/products_configuration_example09186a00800e0dcd.shtml

Configuring PPP Dialin with External Modems

http://www.cisco.com/en/US/partner/tech/tk713/tk507/technologies_configuration_example09186a0080093c31.shtml

Tejal

870
Views
0
Helpful
1
Replies