Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Dial interface reset

Hi

I have a problem where users are trying to dial in, but when the async interface comes up it shows interface reset. The async then immediately goes to down again:

*Nov 6 14:44:36: %LINK-3-UPDOWN: Interface Async0/1/0, changed state to up

*Nov 6 14:44:38: %LINEPROTO-5-UPDOWN: Line protocol on Interface Async0/1/0, changed state to up

*Nov 6 14:45:20: %LINK-5-CHANGED: Interface Async0/1/0, changed state to reset

*Nov 6 14:45:21: %LINEPROTO-5-UPDOWN: Line protocol on Interface Async0/1/0, changed state to down

*Nov 6 14:45:25: %LINK-3-UPDOWN: Interface Async0/1/0, changed state to down

RT_01#

Nothing was changed on the config side of the router.

What could be the problem?

Thanks

willemvw

1 REPLY
New Member

Re: Dial interface reset

From the user side, the modem dials, get the handshake, verify username and password and then when it gets to registering computer on the network, the connection drops. I had the line checked out and it is clean, ie no noise on the line.

I would also like to ask where I can get modemcap strings for the router? I see there is a basic modemcap string "&F1S02".

Any help/suggestions will be much appreciated.

regards

willemvw

399
Views
0
Helpful
1
Replies