I have a project where several PDAs are going to be synching data with my network over dial-up. I have a 2811 router and purchased a HWIC-1CE1T1-PRI card and a PVDM2-24DM module and I have installed them. Can someone point me in the right direction on how I configure this to accept incoming connections so the PDAs can synch with the server on my internal network?
I have only ever done this on the NM-16DM with PRI on a 3600 router, but I imagine the modules you have will configure in much the same way.
The key command is on the PRI control channel interface, and is the line
isdn incoming-voice modem
which makes sure the incomming isdn call from the remote user goes to the digital modem card, and the router can then handle it ok. If the PRI config and that command are there, dial the ISDN number from a normal phone and you should hear the modem answer.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.