1 - AS5400 receiving dial-up calls (ISDN PRI), building L2TP tunnel to 2800 or 7200 router;
2 - AS5400 also receiving dial-up calls but without L2TP tunnel
Based on username some connections need to be disconnected after some time (configured using Session-Timeout Radius parameter). The second option disconnects clearly, but the first one leaves physical line up on the user side, although access server reports line is down. Is this a known bug? Is there some workaround?
Since the access server shows that the port is down, there is no call that is active. What is the version of IOS runnning on the remote end routers that are making the call to the access server. You can try doing an upgrade to the latest version and check the status of the physical line when the call is disconnected.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...