Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Dialup access through auxiliary port

When i dialup to one of my router through the auxiliary port i am faced with a perculiar problem.

I get connect at 9600 baud but I dont get login prompt.

can any let me what could be problem.

thanks in advance.

Regards,

Easwar

2 REPLIES
Bronze

Re: Dialup access through auxiliary port

If the router does not have an enable secret password, incoming connections will not be able to enter the enable mode. To allow incoming calls to enter enable mode, use the enable secret password command to setup the enable secret password.

http://www.cisco.com/warp/public/471/mod-aux-exec.html

http://www.cisco.com/en/US/tech/tk801/tk36/technologies_tech_note09186a008009428b.shtml

New Member

Re: Dialup access through auxiliary port

Hi

if the router config is ok, I can suggest to check the cabling and adaptors...

I experienced the same problems connecting a modem with db9 female rs232.

To solve I had to use a null modem cable with on one side

- db9 male to db9 modem rs232 famale

and on the other

- db25 female to db25 male of the Cisco modem adaptor

But we have to be sure the router config is ok...

If helps pls rate.

Tks

Ric

125
Views
0
Helpful
2
Replies