Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

disconnecting T1s

I have an As5300 that has four (4) T1s connected to it. There’s no need for all of the T1s anymore and I would like to disable two (2) of them. Is there a good way of doing this or any documentation on how to do this? I didn’t set this As5300 up and I’m not very familiar with the configuration. Any help on this matter would be greatly appreciated.

1 REPLY
Silver

Re: disconnecting T1s

Disable the interface with the shut command on the serial interfaces you want to disable.

Take a look at this for additional information.

http://www.cisco.com/en/US/products/hw/univgate/ps501/products_installation_guide_chapter09186a008007de67.html

Hope this helps.

Steve

90
Views
0
Helpful
1
Replies