Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Does this design work?

Two 1841 routers connecting to each other over with WIC-1AM modules. Is it possible to run bridging on all the FastEthernet and Async interface? Is there any example configuration?

Any advise is appreciated!

1 REPLY
Silver

Re: Does this design work?

I did not test this module / bridging and you better to test the command in router physically.

Could you advise why require bridging ? You have to clarify the access-list to allow in the dialer connection.

http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_feature_guide09186a00806c5807.html

Hope this helps.

90
Views
0
Helpful
1
Replies