Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

E1 configuration issues

We are getting 8 mb of bandwidth through 4 e1s from a service provider. They have given us the following information

x.x.x.x My end IP address

x.x.x.x other end IP address

x.x.x.x Network address

x.x.x.x My end IP address

x.x.x.x other end IP address

x.x.x.x Network address

x.x.x.x My end IP address

x.x.x.x other end IP address

x.x.x.x Network address

x.x.x.x My end IP address

x.x.x.x other end IP address

x.x.x.x Network address

They told me to assign the above IPs to your E1 interface (Virtual Serial interface). I don't know how to configure the E1 cards and how to assign the above IP addresses. Please help me in this issue that how can I make the required configurations.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: E1 configuration issues

Sure, glad it helped.

Please rate useful posts using the scrollbox below!

3 REPLIES
Hall of Fame Super Gold

Re: E1 configuration issues

controller E1 x/y

channel-group timeslots 1-31

interface x/y:0

ip address ...

ip route 0.0.0.0 0.0.0.0

Hope this helps, please rate post if it does!

New Member

Re: E1 configuration issues

Thanks p.bevilacqua dear it worked. :) I HAVE TO ASK ANOTHER QUESTION BUT I WILL ASK THIS IN THE NEXT POST.

Hall of Fame Super Gold

Re: E1 configuration issues

Sure, glad it helped.

Please rate useful posts using the scrollbox below!

137
Views
0
Helpful
3
Replies
CreatePlease to create content