E1 extension number

[guilherme.bedin]

Hi,

I have an AS5300 with 8 E1's and r2-digital. I use it to dial-out with telnet. But all calls always apper to come from the caller-id t, one of the main 8 trunk numbers of the E1's. There is a way to set the extension number for each modem for example?

The E1 configuration are:

ds0-group 0 timeslots 1-15,17-31 type r2-digital r2-compelled ani

cas-custom 0

country brazil

metering

category 2

answer-signal group-b 1

thanks,

Guilherme

[paolo bevilacqua]

Ola', good question.

I've searched and cannot find a way todo this. Suggest you configure modem-pool and check if any command let you set calling number (ANI)

[guilherme.bedin]

Good suggestion, bellow the modem-pool options:

Modem pool configuration commands:

called-number Map a called number to modem pool

default Set a command to its defaults

exit Exit from modem-pool configuration mode

help Description of the interactive help system

no Negate a command or set its defaults

pool-range Configure a group range for the modem pool

Did you think that called-number will do the trick?

I also found the link bellow, I will read and try latter.

http://books.google.com.br/books?id=kOMVE58U7mIC&pg=PA138&lpg=PA138&dq=cisco+%22modem-pool%22+as5300+dial-out&source=bl&ots=NEb8nxc1hw&sig=KNOj0chtki-o8YBckYBGvBBBBDo&hl=pt-BR&ei=h_-aSfunOJCCNee6sfML&sa=X&oi=book_result&resnum=3&ct=result#PPA138,M1

[paolo bevilacqua]

Ola'

No, called-number is to tie a pool to a DNIS. I'm afraid, what you want cannot be done.