Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

E1 not working

when i do a 'show isdn status' i get state as TE_1 ASSIGNED or AWAITING_ESTABLISHMENT ,when i do a show int s0/3/1.15 serial is up,line protocol down,what could be the problem?The telco guys say everything is ok on their end though i dont trust them.Thanks

4 REPLIES
New Member

Re: E1 not working

Hi

Could you please provide more information:

1)What kind of hardware are you using - routers and models?

2)How do you configure your E1?

3)What purpose of your E1 link - voice or data?

I had the same problem resently, so perhaps I could help you

Regards

Ivan

New Member

Re: E1 not working

1)cisco 3845 router

3)Used for voice

2)

!

controller E1 0/3/1

framing NO-CRC4

pri-group timeslots 1-31

!

interface Serial0/3/1:15

no ip address

isdn switch-type primary-net5

isdn overlap-receiving

isdn incoming-voice voice

isdn sending-complete

!

!

voice-port 0/3/1:15

cptone KE

!

of course thea are some relevant dial peers which i have omitted...How did u resolve your problem ?

New Member

Re: E1 not working

Sory, but I'm afraid that I can't suggest you anything about E1 PRI for voice. I had a problem with ISDN PRI for data.

In any case, if you want to get help, you should post the some outputs: sh controller e1, sh int ser 0/3/1:15; debug isdn q921/q931.

(You also forgot to indicate the card description)

Good Luck!

Regards

Ivan

New Member

Re: E1 not working

Dear ,

Can you post your

>>> sh isdn status <<<

and >> debug isdn q931 <<

See if layer 2 is not coming up its usually a telco issue ..

cheers

Global ISDN Switchtype = basic-net3

ISDN BRI0 interface

dsl 0, interface ISDN Switchtype = basic-net3

Layer 1 Status:

ACTIVE

Layer 2 Status:

TEI = 97, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED

Layer 3 Status:

0 Active Layer 3 Call(s)

Active dsl 0 CCBs = 0

The Free Channel Mask: 0x80000003

Total Allocated ISDN CCBs = 0

pcdg244#

162
Views
0
Helpful
4
Replies
CreatePlease login to create content