Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

EasyVPN client and internet/local lan access

I connect to my remote network (Pix501) using EasyVPN with a shared key. I have checked the allow local lan access selection on the transport tab but cannot access the internet through my local lan/router. Any suggestions?

4 REPLIES
Silver

Re: EasyVPN client and internet/local lan access

Allowing Local Lan Access would no prevent the internet access.Check for the normal internet troubleshooting fetures such as router configuration.Also check if the NATing is done fine on the router

New Member

Re: EasyVPN client and internet/local lan access

Sorry. I didn't explain myself well enough. I am working from home and using EasyVPN to establish a VPN tunnel through our Pix501 at work to access our work network. I want to concurrently use the internet. What set up is required to do that?

New Member

Re: EasyVPN client and internet/local lan access

You need to configure a split tunnel on the 501. You create an ACL that specifies the split traffic and then you assign it to the VPN group.

New Member

Re: EasyVPN client and internet/local lan access

Split tunnel and ACL has been configured. The problem is that the local computer makes the IP address assigned to the VPN connection (DHCP assigned by the PIX) as the default gateway in the route table.

321
Views
0
Helpful
4
Replies