I have been working on my network for a while now, but I was not involved with the setup/install process. Most of the configuration I have knowledge of except my PIX501.
I am in a lurch because I need to open a port to allow a VPN tunnel for a vendor to update configuration. I have read a ton of pix material and have some direction. Is there a simple way to complete this process and not take down my firewall(mistakes) and still make this effective? Some one please help...
First, my network is closed to the internet. All I need to do is open port 80 for a specific client using password authentication so they may remote into my network and have exclusive access to everything.
Client will be using goto assist...not sure if they have a static IP or not, but it is prefered to have a VPN established for this connection.
Secondly, there is other applications that see the internet, but are isolated from the network, or IP restricted.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.