exec time out means seession waits for the user input before the time out and closing the seession...and its default of 10 minutes you can use the "exec-timeout" command to configure time...
and session time oute is the time interval that the router waits for the traffic before closing the connection and its in minutes...and you can configure it using "session-timeout minutes" command...default is 0...and output key word in this command tell router to use both input and output traffic to reset the counters...if you not use this output key word then only input traffic will cause a counter reset...
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...