We try to configure the remote access VPN in 2811 router but we are facing some problem..
When we first turn on the router it will get authenticate from Radius sever & let the user to access in the LAN through VPN tunnel. But after disconnect the VPN tunnel, same vpn user when try to access the LAN through VPN , in his second attempt everything is ok but Router will not send any accounting information to the Radius Server.
For your convenience here I attached sh tech & diagram .
Looking for your assistance to resolve this problem, Why it is working in first attempt but not later attempt. but After reboot the router Same thing Happen.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...