04-12-2006 02:58 AM
Sir,
I am experiencing "Far end block errors Detected " on NM-2CE1B port. The port is being used for PRI.The controller remains UP but the calls get disconnected very frequently.
Can somebody guide where could be the problem ?
regds,
Aman
Solved! Go to Solution.
04-12-2006 11:38 AM
From my experience, it's always a Telco issue. It indicates there is a physical layer error on the far end of the circuit.
Here's what google picked up for FEBE.
http://www.auditmypc.com/acronym/FEBE.asp
Pls. rate all helpful posts.
HTH,
Sundar
04-12-2006 11:38 AM
From my experience, it's always a Telco issue. It indicates there is a physical layer error on the far end of the circuit.
Here's what google picked up for FEBE.
http://www.auditmypc.com/acronym/FEBE.asp
Pls. rate all helpful posts.
HTH,
Sundar
04-12-2006 11:31 PM
thanks a lot..
there was a pair problem at exchange end..
regds,
aman
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: