So say I have a remote user using a Cisco 871 router located at his\her home, connecting into our hub office using EZVPN. For traffic coming from the users home, I want to filter the traffic based on destination address AFTER it is unencrypted at the hub site... Is this done in the Dynamic Crypto Map? I have tried that, yet I am not getting any hits on my ACL. I don't want to apply this ACL at every single remote router... I would prefer instead to filter at the hub site...
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...