Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

FRAME RELAY HUB AND SPOKE ROUTERS

IN FRAME RELAY HUB AND SPOKE TOPOLOGY

THERE IS STATIC MAP ENTRIES

I HAVE TWO QUESTIONS

1. IF SPOKE ROUTER DO NOT PING EACH OTHER WHAT IS SOLUTION OR EXTRA COFIGURATION REQUIRED

2. IS ONE DLCI FROM A ROUTER MAP WITH TWO REMOTE ADDRESSES.

1 REPLY

Re: FRAME RELAY HUB AND SPOKE ROUTERS

yes you can have it...

lets say router A is hub router and having two spoke router B and router C...

now you can have DLCI like

router A use DLCI 101 to reach B

router A use DLCI 102 to reach C

Router B can use DLCI 201 to reach A and C

Router C can use DLCI 301 to reach A and B

by this way you can have partial mesh configuration and you can have configuration like this...

Router B can use DLCI 201 to reach A

DLCI 202 to reach C

Router C can use DLCI 301 to reach A

DLCI 302 to reach B

hope this will clear your idea

rate this post if it helps

regards

Devang

133
Views
4
Helpful
1
Replies
CreatePlease to create content