Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

how to disallow some ips from NAT overload

ip nat pool nl_nat_pool 213.200.151.169 213.200.151.169 netmask 255.255.255.240

ip nat pool el_nat_pool 124.170.225.105 124.170.225.105 netmask 255.255.255.240

ip nat inside source route-map EL pool el_nat_pool overload

ip nat inside source route-map NL pool nl_nat_pool overload

--------------------------------------------------------------------------------

ip nat inside applied on internal network interface.

--------------------------------------------------------------------------------

Hello folks,

see the configuration above, we have 2 WAN interfaces and all the internal traffic nated here to access internet.

my current scenario is like. i don't want some Internal ips towards a particular destination NATed here.

i.e. say we have 5 vlans.

192.168.2.0

192.168.3.0

192.168.4.0

192.168.5.0

192.168.6.0

all are overloaded at wan interface, now i want to exclude some IPs in Vlan 2 (192.168.3.0) from overloading. (This is for a site to site VPN). Do you peoples have any idea about this.

Anith.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: how to disallow some ips from NAT overload

Why do you post the same question in all forums?

In fact I already answered it under Wide Area Networking so there is no need for this.

Be aware that this is considered impolite and does not help you getting an answer any quicker.

Leo

2 REPLIES

Re: how to disallow some ips from NAT overload

Why do you post the same question in all forums?

In fact I already answered it under Wide Area Networking so there is no need for this.

Be aware that this is considered impolite and does not help you getting an answer any quicker.

Leo

104
Views
0
Helpful
2
Replies