I have a 871 which I need to setup for remote access. I am not sure how to configure this so any help would be appreciated.
The current setup consists of a Cisco 871 router with 1 link to the internet with approx. 5 site to site VPNs. I need to leave current setup as is and just modify to allow LAN access to main site from the internet. I was going to use the Cisco VPN client.
If this question has already been asked, pls just send me in the right direction.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...