I tried to get an HWIC-2SHDLS card to work with AT&T and was unsuccessful. I opened a TAC case and they said that they tried everything possible and there may be a DSLAM incompatability with AT&T and wanted AT&T's DSLAM make and model, which AT&T would not release. Below is the configuration:
controller SHDSL 0/0/0
dsl-group 0 pairs 0, 1
shdsl annex A
shdsl rate auto
no ip address
atm ilmi-keepalive 30
encapsulation aal5mux ppp dialer
ip address negotiated
dialer pool 1
ppp authentication pap chap callin
ppp chap hostname ommitted
ppp chap password 7 asdfdsfd
ppp pap sent-usernameinterface Dialer1 ip address negotiated encapsulation ppp dialer pool 1 dialer-group 1 ppp authentication pap chap callin ppp chap hostname sdfwerghjgwehrjgweghrj ppp chap password 7 sadf ppp pap sent-username username password 7 password
Has anyone gotten it to work with an HWIC-2SHDSL and AT&T?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...