I just installed a HWIC-CABLE-D2 in a 2811 router and connected it to Comcast's nework. The connection works.
However the show controllers cable-modem command tells me it is operating in DOCSIS 1.0 mode. How do i get it to operate in DOCSIS 2.0 mode? Comcast tells me it is not their configuration that is in issue.
After spending long hours on the phone with several "clueless" Comcast technical support folks I learned the following:
1) Their networks is DOCSIS 1.1 so there is no value in running the HWIC in DOCSIS 2.0 mode.
2) They do not support the Cisco HWIC, but no matter since the config file they download to the modem is generic and if they register your modem as a Cisco UBR925 "which as been upgraded to run in docic 1.1 mode" it will register and work.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...