Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

I'm confused!!!!

Hello.

I have a series of 10 cisco 877 and 876 routers and i want to deploy the internal firewall to deny access to everyone except the headquarters ip for management purposes.

Although i choose permit any any for my ip address i cannot access my devices.

How can i setup my routers to access via telnet, ssh and sdm???

Thanks in advance,.

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: I'm confused!!!!

Here how you can limit telnet access by ip address:

Router#config terminal

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#access-list 10 permit 10.8.10.12

Router(config)#access-list 10 permit 10.8.20.5

Router(config)#access-list 10 deny any

Router(config)#line vty 0 4

Router(config-line)#access-class 10 in

Router(config-line)#^Z

Router#

Post your config for further help.

1 REPLY
Silver

Re: I'm confused!!!!

Here how you can limit telnet access by ip address:

Router#config terminal

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#access-list 10 permit 10.8.10.12

Router(config)#access-list 10 permit 10.8.20.5

Router(config)#access-list 10 deny any

Router(config)#line vty 0 4

Router(config-line)#access-class 10 in

Router(config-line)#^Z

Router#

Post your config for further help.

117
Views
0
Helpful
1
Replies
CreatePlease login to create content