Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

interface on 3825 for remote access

Hi,

I have 10 remote site with a PC connected to an analog modem and a phone connection to the PSTN. In the main site I have a 3825 and a E1 line. I want to know the type of card i have to use on the 3825 in order to perform remote access for my 10 remote site.

Regards

4 REPLIES
Purple

Re: interface on 3825 for remote access

Howdy,

You could use the NM-12DM (12 Port Digital Modem Network Module) in order to terminate these calls.

Hope that helps - pls rate the post if it does.

Regards,

Paresh

New Member

Re: interface on 3825 for remote access

Hi,

Ok but the NM-12DM network modules do not provide interface on their own.In addition to the digital modem module, the router must contain a PRI or BRI interface to connect to the ISDN channel. The pb is that i have only one slot for NM module available.

So another solution would be suitable for me.

Regards

Purple

Re: interface on 3825 for remote access

How about getting a VWIC-1MFT-E1 for your E1 ?

Paresh

New Member

Re: interface on 3825 for remote access

Yes,

I think the VWIC-1MFT-E1 card is the right one.

Also have you got a configuration example for my case ?? or a goog link about a sample config ?

Thank a lot !!

237
Views
0
Helpful
4
Replies