One of my users need to work sometimes in second (not our) office and have access to printer. The problem is that the in the remote and local office there is the same network (10.0.0.0/24). VPN's policy distinguish network 10.0.0.0/24 that should go through the tunnel. The printer in the remote office has IP address 10.0.0.102. Is there any posibility to solve it ? I've tried with access-list:
access-list SPLIT_TUNNEL_LIST standard deny host 10.0.0.102
access-list SPLIT_TUNNEL_LIST standard permit 10.0.0.0 255.255.255.0
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...