Currently I have a 3 remote sites connected to a main one as a backup to a leased line.I have baught a cisco router 2811 with an ISDN card NM-1CE1T1_PRI. the 3 remote sites are connected to the main one at 128k and ,i would like to upgrade them to 256k for each site. I have ordered an extra ISDN line. I need to know how i am going to reconfigure the link to take 256k for each site using PRI to BRI connection. I have attached the current 3 config for the remote sites and the current config for the main site
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...