Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ISDN call not working...interface up....debug result

BRI2/0 is up, line protocol is up (spoofing)

Hardware is BRI

History table has a maximum of 100 entries for disconnected calls.

History table data is retained for a maximum of 15 Minutes for disconnected calls.

--------------------------------------------------------------------------------

Call Calling Called Remote Seconds Seconds Seconds Charges

Type Number Number Name Used Left Idle Units/Currency

--------------------------------------------------------------------------------

Out +6567689760 0 0

--------------------------------------------------------------------------------

ISDN BRI2/0 interface

dsl 8, interface ISDN Switchtype = basic-net3

Layer 1 Status:

ACTIVE

Layer 2 Status:

TEI = 64, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED

Layer 3 Status:

0 Active Layer 3 Call(s)

Activated dsl 8 CCBs = 0

The Free Channel Mask: 0x80000003

00:17:15: %ISDN-6-LAYER2UP: Layer 2 for Interface BR2/0, TEI 80 changed to up

000673: 00:17:25: %LINK-3-UPDOWN: Interface BRI2/0:1, changed state to up

000674: 00:17:25: %ISDN-6-CONNECT: Interface BRI2/0:1 is now connected to 006567689760

000675: 00:17:26: %LINK-3-UPDOWN: Interface BRI2/0:1, changed state to down

000676: 00:17:36: %ISDN-6-LAYER2DOWN: Layer 2 for Interface BR2/0, TEI 80 changed to down

can anyone help...

2 REPLIES
Hall of Fame Super Gold

Re: ISDN call not working...interface up....debug result

The interface connects ok, you likely have a ppp problem, check debug ppp neg, debug ppp auth.

New Member

Re: ISDN call not working...interface up....debug result

can i see the config done

154
Views
0
Helpful
2
Replies