Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ISDN: How to check whether its point-to-point or multipoint

Hi, Is there any show/debug command to see whether the isdn link is point-to-point or multipoint?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: ISDN: How to check whether its point-to-point or multipoint

When you configure isdn static tei, it's p-to-p, else, its p-to-mp.

Multinumber BRi are p-to-mp, in fact see your above got assigned a dynamic TEI.

7 REPLIES

Re: ISDN: How to check whether its point-to-point or multipoint

It will only be pt-pt, but you can have multiple calls into a hub depending on the ISDN presentation, ISDN 2 or ISDN PRI.

HTH>

Hall of Fame Super Gold

Re: ISDN: How to check whether its point-to-point or multipoint

Check for no TEI assigned when configured p-to-mp on a p-t-p circuit.

Generally, multiple circuits with a single pilot number are p-t-p.

New Member

Re: ISDN: How to check whether its point-to-point or multipoint

Hi,

we have ISDN2e. I want to check whether this ISDN is p-to-p or p-to-mp. From the configuration, i have not configured it manullay as a point to point or point to multipoint.

On this ISDN we have two ISDN numbers. How can i check it? below is the show isdn status command.

show isdn status

Global ISDN Switchtype = basic-net3

ISDN BRI0 interface

dsl 0, interface ISDN Switchtype = basic-net3

Layer 1 Status:

ACTIVE

Layer 2 Status:

TEI = 115, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED

Layer 3 Status:

0 Active Layer 3 Call(s)

Active dsl 0 CCBs = 0

The Free Channel Mask: 0x80000003

Total Allocated ISDN CCBs = 0

Hall of Fame Super Gold

Re: ISDN: How to check whether its point-to-point or multipoint

When you configure isdn static tei, it's p-to-p, else, its p-to-mp.

Multinumber BRi are p-to-mp, in fact see your above got assigned a dynamic TEI.

New Member

Re: ISDN: How to check whether its point-to-point or multipoint

Hi,

Pls tell me if that BRI configured as Point to point then what will be a value for the TEI

Re: ISDN: How to check whether its point-to-point or multipoint

Check your dialer map statements.

The TEI (Terminal Ennpoint Identifier) is assigned to the line from the exchange.

Hall of Fame Super Gold

Re: ISDN: How to check whether its point-to-point or multipoint

Always 0.

1425
Views
0
Helpful
7
Replies