I have big number of dialout connections . That why i am trying to use the concept of "Large Scale Dialout Using TACACS+". The problem that i have is that, in arround 800 situations i should dialout to standalone systems ( Windows PC's) that can be accessed remotly through an analog modem. All these systems have the same IP address. Can i use the concept of "Large Scale Dialout Using TACACS+" to send NAT Informations also, i.e, is it possible to send the Tel, nr. and routing informations an then the NAT command to translate the ip address in the dialer command which is not the real address of the end system to the real one.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...