I have a linksys WRVS4400N VPN gateway installed on my network edge. Now i need to connect to it using a VPN Client over internet. But don't have a client. Can anyone tell me which client to use & wheere to download it from?
I have downloaded QVPN Utility & installed on my laptop. I just configured my router (linksys WRVS4400N) & wanted to check locally before installing at remote location. I assign IP address (188.8.131.52/26) on WAN port & 192.168.2/6 on LAN port. Connected its WAN port to my local switch. Configured my laptop with a 115.113.89.x IP with same (/26) subnet. Now i want to connect it using QVPN Utility & ping 192.168.1.2 to test it. But, when i try to do this.. It stops on "verifying Network" and ends up with message: "The remote gateway is not responding. Do you want to wait?" Please tell me what to do or if i have done anything wrong.
Rahul, best is to test from outside source, configure the device for RA VPN server and have a client from the outside VPN in.. that way you can connect from inside your LAN to the WRVS4400N device and look at logs while the outside source connects, have the client access inside resources once connected.
Thanks for your suggesion. I tried from outside too, but didn't worked. Afterthat, i tried greenbow IPsec client. Configured using configuration guide (attached herewith). First i connected everything worked fine. But cannot establishe tunnel anothertime unless i reboot gateway (WRVS4400N). What i noticed is, when i close a opened tunnel on client on my pc. It donot closes tunnel completely, and stayes with warning "tunnel remaining on gateway". Can you please help me in this. Do i have made any wrong configuraiton.
Install QuickVPN client ,dont change compatibility mode.. Make sure the Windows 7 firewall is turned on. Restart your computer then:
1. Right click on Computer Icon 2. Select Manage 3. Select Services and Applications 4. Select Services 5. Sort by Name 6. Look for and right click on IKE and AuthIP IPsec Keying Modules (Should not be disabled, if so, do the rest below) 7. Select Properties 8. Make Startup Type be: Automatic 9. Restart PC and try QuickVPN..
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...