Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Modem on Aux port on 2801 not prompting for login

Hi,

I have a US Robotics model 5686E connected to the AUX port on a 2801 router. I can connect to the modem, but I don't get prompted for login. I can never get to the router prompt. Here's my AUX config:

line aux 0

modem InOut

modem autoconfigure type usrmodem

autocommand menu peach1

transport input all

autoselect ppp

stopbits 1

speed 2400

flowcontrol hardware

The "modem autoconfigure" line references this line in the config:

modemcap entry usrmodem:MSC=&FS0=1&C1&D3&H1&R2&B1

Here's my authentication setup:

aaa new-model

!

!

aaa authentication login default group tacacs+ local

aaa authentication ppp default group tacacs+ local

aaa accounting exec default start-stop group tacacs+

aaa accounting commands 15 default start-stop group tacacs+

aaa accounting connection default start-stop group tacacs+

aaa accounting system default start-stop group tacacs+

!

aaa session-id common

!

I've tried different speeds with the modem and several other minor tweaks with no success. I know I'm connecting to the modem because I can see it connect and I can pass keystrokes, but I can't get to the router prompt. Any suggestions would be greatly appreciated.

1 REPLY

Re: Modem on Aux port on 2801 not prompting for login

can you try disabling the AAA?

Also make sure the jumper settings are proper in the modem.

http://www.cisco.com/en/US/tech/tk801/tk36/technologies_tech_note09186a0080094bbc.shtml

http://www.cisco.com/en/US/tech/tk801/tk36/technologies_tech_note09186a00800941c9.shtml

HTH, rate if it does

Narayan

282
Views
0
Helpful
1
Replies
CreatePlease to create content