Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAM-16 V2 modems failing to answer

I have a 2811 Router with a NAM16 V2 modem card in it that we use for POS (point-of-sale) terminal dial-up.

The modems are configured as Dialin and we also have an Autoconfigure line that does an S=0 command to put the modems into Auto answer mode, however the modems never asswer the ring tone.

I have run a debug modems command and have confirmed that the modems see the incoming ring tone, but I can't get them to answer the incoming call.

Any ideas.

I have attached a copy of the config for one of the modems along with a copy of modemcap entry that we are running.

I have similar installs elswhere running on 2611 routers with the older NAM16 version 1 module and these are fine. I have compared the configurations line by line and can't see any obvious differences.

113
Views
0
Helpful
0
Replies