Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

NAT Problem with Remote Access?

My office runs a small business server with a Cisco 1811 in front. I need to access ports 80 and 443 from the outside so I used a static NAT for the server IP. I also setup IPSec VPN on it. When I remote in, I can access anything on the network except for the server which is NAT'ed. If I remove the NAT, I can access the server through the VPN. Any idea why this is happening? What part of the config would you need to see to better assist in resolution?

1 REPLY
New Member

Re: NAT Problem with Remote Access?

Hi,

maybe "below" is needed

access-l 100 deny ip host (server_ip)(vpn_peer_ip) (netmask)

access_l 100 per ip (server_ip) any

ip nat inside source list 100 pool nat_pool

ip nat pool nat_pool (server_ip)

95
Views
0
Helpful
1
Replies